First of all, based on the test results, a model for dynamically describing the erosion morphology of the inner wall of perforations was established. The test results show that as the sand concentration in the sand - carrying fluid increases, both the maximum diameter of the inner wall of the perforation after erosion and the pumping pressure drop amplitude gradually increase. This indicates that a higher sand concentration will aggravate the erosion of the inner wall of the casing, thereby affecting the fracturing effect and the safety of tool running - in.
Secondly, it was found that the thickness of the proppant adhesion layer on the inner wall of the casing gradually increases from the heel end to the toe end of the wellbore. This trend will reduce the inner diameter of the lower - level casing by about 35 mm, bringing challenges to fracturing construction and tool running - in.
Moreover, as the sand concentration gradually increases, the adhesion amount at the heel end of the casing gradually increases, and the adhesion amount at the toe end gradually decreases, which reflects the differences in different positions during the erosion process. Furthermore, as the sand concentration in the sand - carrying fluid increases, the crushing degree of the proppant after erosion also gradually increases, and the proportion of debris increases. This will affect the performance of the fracturing fluid, causing the reduction amplitude of the fracturing fluid viscosity after erosion to first increase and then decrease, with the maximum reduction reaching 52%.
Finally, based on the above - mentioned test results, a numerical model for proppant migration in high - speed erosion of casing was further established to analyze the law of proppant particle migration in the casing. This model not only verifies the model for dynamically describing the erosion morphology of the inner wall of perforations, but also provides an important basis for optimizing construction parameters in horizontal well fracturing and reducing the risk of tool running - in blockage.
In conclusion, through a series of tests and model establishment, this research deeply reveals the downhole behavior characteristics in high - speed erosion of casing in horizontal well volume fracturing, provides strong support for the further development and optimization in this field, and is expected to play an important guiding role in actual fracturing construction, reducing construction risks and improving fracturing effects.
