I. Sealing System Failure
Sealing Surface Processing Defects
Irregular sealing surface grinding or presence of cracks/scratches, preventing effective sealing lines
Accelerated wear due to low hardness of sealing materials (substandard overlay welding/heat treatment)
Hard particle contamination damaging sealing surfaces (inadequate pipeline purging)
Dynamic Damage to Sealing Components
Wear or improper alignment of the stem-closure connection, causing closure misalignment
Micro-cracks from thermal contraction (post-closure rapid cooling)
Accelerated wear of soft seals (e.g., PTFE) due to insufficient lubrication
II. Material and Manufacturing Defects
Structural Integrity Issues
Casting voids or welding defects in valve bodies (common in low-pressure valves)
Insufficient manufacturing precision of balls/seats (roundness deviation >0.02mm)
Material Selection Errors
Corrosion resistance mismatch between sealing materials and medium (e.g., Cl⁻ attack)
Stem bending deformation from inadequate material stiffness (deflection >1‰)
III. Operational and Maintenance Errors
Improper Valve Operation
Sealing surface collapse from over-torque closure (exceeding lever limits)
Stem thread damage from forced rotation in partially open state
Maintenance Deficiencies
Insufficient/incompatible grease injection (viscosity mismatch)
Seat spring corrosion from prolonged storage
IV. Installation and Construction Issues
Assembly Process Failures
Valve core-seat centerline misalignment (>0.5mm)
Non-uniform flange bolt preload (torque deviation >15%)
Environmental Control Lapses
Thermal deformation from welding with stem intact (temperature rise >200°C)
Ice blockage-induced seal damage due to missing freeze protection
Key Parameter Thresholds
|
Failure Type |
Critical Threshold |
|
Sealing surface flatness |
≤0.001mm (post-grinding) |
|
Stem straightness deviation |
≤1mm/m |
|
Grease injection pressure |
1.2-1.5× medium pressure |
|
Flange bolt preload torque |
ASME B16.5 standard ±5% tolerance |
