Mar 07, 2025

Research on the Compressive Deformation Behavior of Basal - textured AZ31 Magnesium Alloy Based on Local Strain Analysis

Leave a message

Introduction For the basal - textured magnesium alloy under in - plane compression, its deformation behavior is complex, involving twinning, dislocation gliding and their interaction. The purpose of this study is to deeply explore the deformation mechanism during the compression process of this magnesium alloy, use advanced technical means to quantify the deformation behavior, and provide a theoretical basis for the application and performance optimization of magnesium alloys.

 

Experimental Methods The electron back - scatter diffraction (EBSD) and high - resolution digital image correlation (HR - DIC) techniques were used to characterize the deformation behavior of the AZ31 alloy under in - plane compression. The EBSD maps and {0001} pole figures under different nominal compressive strains were observed, the strain evolution processes dominated by twinning and slip were compared, and the characteristics such as lattice distortion and strain distribution were analyzed.

 

Results and Discussion (1) Initial Material Characteristics The initial material has equiaxed grains with an average grain size of about 20μm and has strong basal - texture characteristics. Most of the C - axes of the grains are parallel to the ND - axis, which creates favorable conditions for twinning activation. (2) Twinning Activation and Propagation As the nominal compressive strain increases, the twinning is gradually activated and significantly propagates. The twinned area fraction increases from 29.3% at 2.2% to 58.6% at 6.8%. The strain in the twinned region is uniform, mainly coordinated by propagation; if the dislocation slip is not activated, the strain in the twinned region will not continuously increase with the applied compressive strain. (3) Interaction between Twinning and Slip There are two modes of interaction between twinning and slip: twinning first and then slip or slip first and then twinning. Twinning can adjust the misorientation to adapt to slip, consume the matrix and then activate more basal - plane slips. In some cases, the additional effect between twinning and slip is weak. (4) Local Strain Characteristics Lattice distortion mainly occurs at the tips of twinned lamellae and rarely occurs inside the twinning; there are differences between the local strain and the global strain represented by HR - DIC, and the lattice misorientation can only be used for qualitatively representing the average strain. (5) Twinning across Adjacent Grains Twinning across adjacent grains shows smooth strain transfer, which may be because the stress concentration around the twinning tips helps to activate twinning nucleation in adjacent grains; while slip near the grain boundary will cause obvious strain concentration.

 

Conclusions Through local strain analysis, the deformation behavior of the basal - textured AZ31 magnesium alloy under in - plane compression is deeply understood. Twinning plays an important role in the deformation, coordinates the strain by propagation, and the interaction with slip affects the deformation mechanism; twinning across adjacent grains can achieve smooth strain transfer, and slip near the grain boundary will lead to strain concentration. These results provide important theoretical guidance for the design and performance optimization of magnesium alloys.

Send Inquiry