I. Microstructure Morphologies of Dual - phase Titanium Alloys
Duplex Structure If deformation occurs in the upper temperature region of the two - phase region, or if it is reheated to the upper temperature region of the two - phase region after deformation in the two - phase region and then air - cooled, a duplex structure can be obtained. The characteristics of this structure are as follows: Isolated primary α particles are distributed in the β - transformed microstructure, and their volume fraction is generally less than 50%. Moreover, the α phase has two morphologies: equiaxed primary α phase and lamellar secondary α phase in the β - transformed microstructure.
Widmanstätten Structure When the starting and ending temperatures of deformation of the dual - phase titanium alloy are both in the β - phase region and the amount of deformation is not large, or when the dual - phase titanium alloy is heated to the β single - phase region and then slowly cooled, a Widmanstätten structure will be obtained. This structure has coarse original β grains, with grain - boundary α phase distributed on the grain boundaries, and lamellar α and β phases are alternately distributed inside the grains. Moreover, if the cooling conditions are different, the morphology and distribution of the grain - boundary α phase will also be different.
Equiaxed Structure When the dual - phase titanium alloy is deformed in the two - phase region 30 °C - 50 °C below the β - phase transformation point, an equiaxed structure can be obtained. Its characteristic is that a certain amount of β - transformed microstructure is distributed in the equiaxed primary α - grain microstructure with a content of more than 50%, and changes in deformation conditions will affect the quantity and microstructure morphology of the primary α phase.
Basket - weave Structure When the dual - phase titanium alloy is deformed near the β - transformation temperature, or when deformation starts in the β single - phase region, ends in the two - phase region and the amount of deformation is between 50% and 80%, a basket - weave structure is generally obtained. Its characteristic is that the α lamellae in the original β grains become shorter and are staggered and arranged in a woven - basket - like pattern.
II. Performance Characteristics of Dual - phase Titanium Alloys
Duplex Structure and Equiaxed Structure The titanium alloy with duplex structure has high fatigue strength and plasticity, which is similar to that of the equiaxed structure. The performance differences between the two structures mainly depend on the difference in the quantity of the primary α phase. As the quantity of the primary phase increases, the reduction of area and the fatigue limit increase, the change in strength is not obvious, while the creep resistance and the long - term strength decrease.
Widmanstätten Structure The plasticity of the Widmanstätten structure is low, and the situation will be further worsened after strengthening heat treatment. However, its fracture toughness is significantly better than that of the equiaxed structure. This is because the existence of the grain - boundary α phase reduces the tendency of intergranular fracture, increases the crack - propagation path, and thus inhibits crack propagation, and its long - term strength is closely related to the quantity and distribution state of the secondary α phase.
Equiaxed Structure and Duplex Structure The performance characteristics of the equiaxed structure and the duplex structure are similar, but there are certain differences with the change in the quantity of the primary α phase.
Basket - weave Structure and Widmanstätten Structure Compared with the Widmanstätten structure, the basket - weave structure has higher plasticity, which can usually meet the service requirements, and also has higher fatigue performance, but lower fracture toughness. For components under long - term high - temperature stress, the basket - weave structure is often used because it is relatively balanced in terms of plasticity, creep resistance, high - temperature long - term strength, etc., and has good comprehensive performance.
In conclusion, the diversity of the microstructures of dual - phase titanium alloys determines that there is a large adjustment space for their mechanical properties. Different microstructure morphologies have their own characteristics in terms of fatigue strength, plasticity, fracture toughness, long - term strength, etc., which provides rich choices for their applications in different fields.
