First, in terms of material preparation, a 3 - mm - thick ZK61 - T5 magnesium alloy plate was used as the base material, and the plates were laminated layer by layer according to the principle of friction stir lap welding using FSAM technology. A specific - size stir - tool was selected, and the process parameters for multi - layer FSAM were determined through preliminary single - layer experiments.
Secondly, in the study of microstructure, a high - strength ZK61 magnesium alloy laminated block was successfully fabricated by the FSAM process. The microstructure in the additive zone presented uniform and fine equiaxed grains, with the grain size ranging from 2 to 6 μm, which was the result of dynamic recrystallization during the FSAM process. Especially in the secondary stirred zone, the degree of dynamic recrystallization was more intense, effectively and uniformly refining the grains and making the microstructure more compact. Moreover, the primary stirred zone (SZ), the secondary stirred zone (re - SZ) and the reheated zone in the stirred zone were carefully observed respectively. Among them, due to the special processing conditions in the secondary stirred zone, the grain refinement effect was remarkable, laying the foundation for the improvement of mechanical properties.
Furthermore, in terms of mechanical properties, the layer - by - layer tensile results showed that the average ultimate tensile strength (UTS) in the uppermost additive zone could reach 320 MPa, exceeding 275 MPa of the base material, and the UTS in the horizontal direction could also reach 265 MPa. However, due to the high texture intensity of the product, the anisotropy increased, and the average ultimate tensile strength in the building direction was only 40% of that in the horizontal direction, that is, 109.5 MPa, indicating that the ZK61 magnesium alloy components fabricated by FSAM had obvious anisotropy. Meanwhile, the micro - hardness in the stirred zone was between 55 and 70 HV, slightly lower than the hardness of the base material. These mechanical property data fully reflected the significant influence of the FSAM process on the mechanical properties of ZK61 magnesium alloy.
In terms of research methods, an optical microscope (OM) and electron back - scatter diffraction technology (EBSD) were used to characterize the microstructure in the additive zone. Tensile specimens were prepared along different directions for tensile tests and the fracture morphology was observed. A Vickers hardness tester was used to test the hardness at different positions on the cross - section of FSAM components.
From a large number of pictures obtained from the experiment, such as the FSAM schematic diagram, the N - layer construction and the corresponding cross - section diagrams of the construction, tool sizes, specimen positions, hardness and EBSD test areas, and schematic diagrams of tensile and metallographic specimen sizes, to the cross - section macro - morphology diagrams of the additive zone under different parameters, the variation diagrams of the tensile strength of single - layer FSAM components at different transverse velocities, the variation diagrams of the tensile strength of single - layer FSAM components at different rotational speeds and different transverse velocities, the macro - morphology diagrams of the multi - layer FSAM additive zone, the EBSD images and grain size diagrams of E1, E2 and E3 regions, pole figures and inverse pole figures, KAM diagrams, local orientation distribution and orientation difference distribution diagrams, Schmidt factor distribution diagrams, as well as the mechanical property diagrams of different samples, the variation diagrams of hardness along the horizontal and building directions, and the fracture morphologies of different samples, all - roundly showed the microstructure evolution and mechanical property characteristics during the fabrication of ZK61 magnesium alloy by FSAM.
In conclusion, the FSAM process is a promising method for fabricating ZK61 magnesium alloy. It realizes the uniform refinement of microstructure and the significant improvement of mechanical properties through a unique process, but also faces problems such as anisotropy. In the future, with in - depth research and improvement of FSAM technology, ZK61 magnesium alloy will have more extensive applications in aerospace, automotive and other fields.
