The western area of Sulige Gas Field is a typical water - bearing tight sandstone gas field. After more than 20 years of exploration and development, by 2024, the natural gas output has exceeded 300 × 10⁸ m³. However, most of the gas wells put into production in the western area of this gas field have water production to varying degrees, and the water - gas ratio varies widely, which severely restricts the long - term stable production and efficient development of natural gas.
From the perspective of the gas - water distribution law in the gas field, the western area of Sulige Gas Field is generally close to the gas - water transition zone at the reservoir boundary, with relatively weak hydrocarbon generation intensity and poor ability to displace formation water, existing in the form of gas - water in the same layer, and the water saturation of effective reservoirs is relatively high. Production wells often produce gas and water simultaneously and have wellbore fluid accumulation. At the microscopic level, the occurrence states of residual formation water are diverse, the relative permeability of gas phase decreases faster than that of water phase, the irreducible water saturation is lower than that at normal temperature, and the relatively high movable water saturation seriously affects the gas well production.
Regarding the two - phase equation considering the variable water - gas ratio, the newly established equation can accurately describe the productivity change rules in the whole life cycle of water - producing gas wells in tight gas reservoirs. This equation is based on seepage theory and gas reservoir engineering methods, taking into account factors such as reservoir stress sensitivity, permeability change, and water - gas ratio change. By establishing and solving the mathematical model, the gas well productivity can be calculated more accurately, providing a strong basis for gas well production management.
Different types of water - producing gas wells have different production characteristics. The water - gas ratio of condensate water is so small that it can be ignored; the reservoirs where water is located at the low structural part have good physical properties and serious water production, which are high - water - production types; the inter - layer - retained water is distributed dispersedly with a small water production amount, belonging to medium - or low - water - production types; lenticular water is distributed in isolation and can be identified by well logging to avoid production. The low - water - production - type gas wells are predicted to have the highest final cumulative gas production, the medium - water - production - type gas wells are the key wells for implementing optimization measures, and the water production in the later production stage of high - water - production - type gas wells seriously affects the productivity.
The production allocation optimization of water - producing gas wells is the key to improving the recovery factor and economic benefits of gas reservoirs. The newly established critical liquid - carrying flow rate calculation model combines the reservoir and the wellbore, taking into account the influence of the reservoir gas - and - water - producing ability on the liquid - carrying flow rate, and the calculation results are in line with the actual production situation. By establishing the production allocation optimization chart and process for water - producing gas wells, the water - production type can be determined according to the water - gas ratio characteristics of gas wells, and the corresponding production allocation method can be determined to realize the reasonable production allocation of gas wells.
The differential management technical countermeasures in the whole life cycle of gas wells are very important. The life cycle of water - producing gas wells is divided into three stages: natural continuous production stage, measure - continuous production stage, and intermittent - production - between - measures stage. In different stages, corresponding technical countermeasures are formulated according to the water - production types and production characteristics of gas wells. For example, in the natural continuous production stage, drainage gas recovery measures are basically not required, and mainly productivity evaluation and production allocation optimization are carried out; in the measure - continuous production and intermittent - production - between - measures stages, according to the fluid - accumulation timings of different types of gas wells, drainage gas recovery measures such as foam drainage, velocity string, plunger drainage, and gas lift drainage are respectively adopted.
Different types of water - producing gas wells are affected by fluid accumulation to different degrees, and the adopted drainage gas recovery processes and intervention timings are also different. Medium - water - production - type gas wells should be vigorously intervened from the early production stage, and the gas well life can be extended with the assistance of supplementary energy or process measures; high - and low - water - production - type gas wells can discharge fluid accumulation by their own abilities in the early stage, and the drainage process intervenes later, which can save costs.
In conclusion, the formed differential management technical countermeasures in the whole life cycle of water - bearing tight sandstone gas reservoirs can increase the cumulative production of water - producing gas wells, solve the problems of poor current development effect and low recovery factor in the western area of Sulige Gas Field, provide technical support for the continuous stable production of the gas field, and have important reference significance for the development of the same type of gas reservoirs. In future development, these technical countermeasures should be continuously studied and optimized to better meet the challenges of developing water - bearing tight sandstone gas reservoirs and realize the efficient development and sustainable utilization of gas reservoirs.
